This document has been substantially revised from the previous 2002 edition, INCLUDING THE ADDITION OF INFORMATION FROM ANSI/MSS SP-69, MSS SP-77, MSS SP-89, AND MSS SP-90. This Standard Practice establishes the material, design, fabrication, and inspection criteria to be used in the manufacture of standard types of pipe hanger components.

This Standard Practice establishes the allowable stress values for materials used in standard types of pipe support components and unique hanger design assemblies. This Standard Practice establishes minimum design load ratings for rigid pipe hanger assemblies. This Standard Practice presents the recommended practice for the selection and application of pipe hangers and supports for all service temperatures.

This Standard Practice establishes recommended procedures for detailing, fabrication, and installation of pipe hangers and supports. Contact us Subject For any question about a product, an order If a technical problem occurs on this website E-mail address Message.

MSS SP-58-2009-COVER.jpg (78.18 KB, Downloads: 0) 2011-6-19 01:42 Upload TABLE OF CONTENTS -------------------------- FOREWORD......... Ii 1 SCOPE.......... Windows 7 ultimate gamer edition x64 download.

1 2 OBJECTIVE......... 1 3 MATERIALS......... 1 4 ALLOWABLE STRESSES, LOAD RATINGS, AND TEMPERATURES... 3 5 PIPING SYSTEMS........ 7 6 GENERAL REQUIREMENTS.......

11 7 PRODUCT DESIGN........ 13 8 SPRING DESIGN........ 16 9 TOLERANCES......... 19 10 PROTECTIVE COATINGS........ 20 11 TESTING OF HANGER COMPONENTS...... 21 12 MANUFACTURE AND FABRICATION......

Ansi/Mss Sp-58-2009 Pdf. 5/3/2017 0 Comments Download international and US standards from the full collections of ISO and IEC standards, American National Standards and thousands of regional and foreign standards. Supports & accessories vimco tm pipe / duct pipe hangers / pipe clamps pipe supports piping / ducting accessories rev.

22 13 PACKAGING, MARKING, SHIPPING, RECEIVING & STORAGE... 28 14 HANGER INSTALLATION PRACTICES...... 29 15 INSPECTION......... 36 TABLES --------- 1 Minimum Design Load Ratings for Pipe Hanger Assemblies.... 2 2 Load Ratings of Carbon Steel Threaded Hanger Rods..... 5 2M Load Ratings of Carbon Steel Threaded Hanger Rods (Metric).... 6 3 Recommended Minimum Rod Diameter for Single Rigid Rod Hangers...

8 4 Maximum Horizontal Pipe Hanger and Support Spacing..... 10 5 Spring Support Selection........ 12 6 Clamp Tolerances........ 19 7 Preheat and Post-Weld Treatment Requirements..... 25,27 7M Preheat and Post-Weld Treatment Requirements (Metric)....

26,27 8 Inspection Checklist........ 36 A1 Hanger and Support Selections....... 40-41 A2 Materials and Allowable Stresses....... 42-44 A2M Materials and Allowable Stresses (Metric)...... 45-47 A3 Type 40 Protection Shields for Insulated Pipe and Tubing..... 48 FIGURES ---------- 1 Solid Design Stress (Uncorrected) for Helical Hot Wound Quenched and Tempered or Helical Cold Wound Springs Tempered After Forming...... 17 2 Solid Design Stress (Uncorrected) for Cold Wound Compression Springs...